Cycle News - Archive Issues - 1990's

Cycle News 1993 06 23

Cycle News is a weekly magazine that covers all aspects of motorcycling including Supercross, Motocross and MotoGP as well as new motorcycles

Issue link: https://magazine.cyclenews.com/i/127581

Contents of this Issue

Navigation

Page 26 of 71

What secrets lurk under the fairing of the factory Honda NSR500s? Fuel-injection? Many feel the system has been used at least twice thus far in 1993 on the Rothmans-backed bikes. would drop to 8000 rpm before the engine could be made to fire properly again," he admitted. HRC rejected the option of adapting a four-stroke system for two-stroke use because the extra parameters that would need to be added "would necessitate a large and heavy system." Instead, they went back to the basic map of throttle-opening/engine speed, and built in a pair of dual-response misfire recovery programs developed directly to cure four-stroking. Two systems, because neither one is suitable to do the whole job over the full range of throttle openings. The first is triggered by intake vacuum, measured between the throttle and the reed valve. This drops significantly when the dreaded misfiring strikes. However, at big throttle openings, the vacuum is in any case extremely small, and would require "a highly precise measurement system" to distinguish the drop-off. Luckily, another factor has by now become more significant. This is combustion pressure, with large differences between firing or four-stroking. This is measured by a sensor in the sparkingplug gasket, and gave the designers a control parameter to take over from the manifold-vacuum system. The first vacuum-triggered system opera tes up until three-quarter throttle; the combustion-triggered map cuts in from there to full-throttle. A further special two-stroke program measures exhaust-gas temperature. Why is this important? Back to the musical role-model of a resonating instrument: at different temperatures (and thus dens"ities) the exhaust resonates at different frequencies. Honda's paper sums it up succinctly: "Fluctuation in exhaust gas temperature ...generates...an effect identical to changes in exhaust pipe length. By influencing the engine's efficiency as a pump, it also alters the amount of fuel required to maintain ideal mixture strength, which the injection management system must take into account." In addition, the system takes the usual parameters of engine temperature (measured via the coolant), ambient temperature and ambient pressure, as does a four-stroke system. Honda's document remained mute on the subject of ignition, which must however be in tegra ted in the engine management system. All of this begs the questions - do carburetors manage to cope with misfiring without all this fuss and bother? And if so, why do they need to be replaced with complex and clearly trick.y injection systems? The answer lies in the different nature of the two systems. A carburetor is an instrument of response. It delivers to the engine what the engine asks of it. Thus when the engine four-strokes, it loses pumping efficiency and sucks less gas through the carburetor a.ccordingly, so (if the carburetion is accurate) the condition cures itself. Electronic fuel injection, on the other hand, is an instrument of initiation. It is giving the engine what it thinks the engine needs - or, to be precise, what its designer thinks the engine needs, the accuracy of his assessment being crucial to the whole affair. The performance benefits of a wellwrought system are manifold. Carburetors are necessarily crude mechanical devices, and can only give a relatively crude set of responses. It is difficult enough to adjust them to provide accurate mixture over the full rev range under static laboratory test conditions; and impossible to arrive at anything but an approximation in use. An injector, on the other hand, constantly updates and adjusts every time the engine fires, and if correctly mapped can provide exactly the correct mixture strength whatever the circumstances. This was proved in action and in various bench-testing simulations of circuit conditions. The Honda system uses two injector nozzles for each cylinder - one not being sufficient to cope with full-throttle fuel requirements. They are placed in the throttle body, exactly replacing the carburetors. High pressure fuel is delivered by a compact, lightweight pump driven off the crankshaft. The injected engine directly matched the power of a carbureted engine, but with consistently accurate fuel-air ratios compared with big variations shown by carburetors. The effective rev range was broadened top and bottom, drivability was improved, and fuel consumption cut by between five and 10 percent. Thus the paper presented to the SAE. But what about now? "Wait one more year," said Honda's Three Wise Men. Fuel injection - the philosphy The reasons for developing fuel injection go beyond short-term race success, and start to impinge on areas of pure research. By making the racing twostroke a more efficient engine, who knows what benefits may be found for future road application, both on two wheels and four. One ad vantage highlighted by lkenoya was the possibility of reducing lead in fuel as a direct result of improved mixture control over a wide rev range. Tuning a racing carburetor for top-en.d performance wa.s at the expense of low-range and mid-range response, he said, and vice versa. Fuel injection requires no such trade-offs, and this improved efficiency opens the door to minimizing lead content at a stroke, and making an accordingly cleaner engine. He also identified practical difficulties of the new technique - weighing the familiarity of carburetor technology against the great unknown of injection. "We would need many people with computers," he said. Meaning many more than they already have, one supposes. Later, he expanded on the HRC philosophy on injection in a private conversation, taking the chance to establish a link between the apparent mindless hedonism of racing and a possible contribution to the future of mankind "We like technology that is of general benefit. For example traction control, low-lead and no-lead combustion, and better fuel technology, which improve safety and reduce pollution when applied to road-going vehicles. "We do not so much like specialized technology - like the carbon brake, which is very good for racing motorcycles, but which is expensive, and no good in rain, or can break if hit by a stone." (As happened once to Gardner's works Honda at Spa, of all places.) Carbon brakes have so far had no production possibilities - they are just expensive racing parts. It is certainly responsible and probably sincere to hope that racing means 25

Articles in this issue

Archives of this issue

view archives of Cycle News - Archive Issues - 1990's - Cycle News 1993 06 23